4. INTERVALOMETER MODES
4.1. SHUTTER RELEASE MODE
Use this mode when you only need to take a single picture manually. Depending
on the mode settings, the Pluto Trigger either simply instructs the camera to
release the shutter with the current in-camera settings, or attempts to time an
arbitrary exposure by using camera’s Bulb mode.
You can choose one of the following release modes to take a picture:
1.
Single: press to take a single picture
2.
Focus: press to focus, release to take a picture
3.
Hold: press to open shutter, release to end exposure
4.
Lock: press to open shutter, press again to end exposure
5.
Bulb: set exposure time, press to take a picture
6.
Burst: set interval, press to start a exposure sequence
7.
Timed: set countdown and start, take a picture when countdown finishes
For “Hold”, “Lock” and ”Bulb” release modes, set your camera to BULB mode. For
others, you may use any exposure mode on the camera, including fully
automatic exposure modes. Please note that Manual focus mode should still be
used.
Usage
1.
Make sure your camera is connected and set up.
2.
Make sure Pluto Trigger is connected.
3.
Select "Shutter Release" from app’s menu.
4.
Select a release mode; set the time if needed.
5.
Press red "Start" button to take a picture.
To Next Page
Loading...