02.02 Connections
• Before positioning the Machine, ensure that the bearing surface is a horizontal level. If the
electric Pedal control is present, insert its plug in the correct appropriate socket to be found at
the side of the machine.
• Connect the machine to the electric power supply, then:
• Ensure that the tension and frequency of the power supply correspond to that written on the
plate.
• Ensure that that socket is connected to earth.
• The Manufacturer specifies that the mains line should be equipped with safety devices by a
differential switch, coordinated with the general earth installation, in conformity with the local
and national laws.
• Check that the safety devices of the Machine are present and assembled before activating the
machine.
Using the Machine for the first time:
• Clean carefully with a soft, clean cloth
• Repeatedly pass a piece of dough through the rollers.
CONNECT THE MACHINE ONLY TO PARTS OF THE ELECTRICAL PLANT WHICH
ARE INDIVIDUALLY PROTECTED, I.E. WITH A DIFFERENTIAL SWITCH
CHECK THE ELECTRICAL STANDARDS OF THE COUNTRY IN WHICH THE
MACHINE IS INSTALLED DO NOT REMOVE THE SAFETY DEVICES WHEN THE
MACHINE IS IN USE.
On delivery, this Manual for the Use and Maintenance containing the Declaration of Conformity of the
product with the EC regulations, is attached to the machine and considered an integral part of it.
The machine arrives in a single package ready for use. Take care to handle the box only manually,
always keeping it in an upward position as indicated on the box.
To Next Page
Loading...