AWA Troubleshooting
19. AWA seems to have a flat line display for the surge test, all other tests work
normally.
20. AWA will not properly apply a programmed 6000 volt surge test, gives a flat top on
the surge display that stops at approximately 5800 volts.
21. AWA always gives "RELEASE THE TEST SWITCH" and/or "TURN OUTPUT
CONTROL KNOW TO ZERO" messages when attempting to begin test sequence.
22. AWA trips when trying to perform a meg-ohm/PI/HiPot on a motor with a long cable
run, yet other manufacturers meggers and HiPot show the cable run/motor as being
good.
23. AWA always "hangs" up after concluding a resistance balance test sequence.
24. When replacing either the 80-100 ADD/IO board or the 80-123 FAST A/D board,
they will not properly function.
25. AWA no longer works after installing a newer version of Analyzer software.
26. AWA does not properly save results, reporting "Unable to update temp results table".
27. AWA "Enable test id edit" password has been lost.
28. AWA does not work properly with PP30D, even after PP30D operation has been
verified with another AWA or D series Tester.
29. AWA gives NESTED failure on surge test sequences.
30. AWA/PP30D combination loses the "SAVE RESULTS" key, after completing a
PP30D test sequence.
31. AWA temperature probe gives erratic readings.
32. AWA will not boot properly, giving messages such as "Drive is not ready", "Insert
boot diskette in drive A", etc.
33. AWA crashes after installing Micro-Solutions Backpack CD-RW.
34. AWA Screen has a bunch of horizontal lines.
35. AWA smokes after plugging in into PATRIOT U.P.S. or SOLA.HEVI-DUTY U.P.S.
power supply.
To Next Page
Loading...