to Friday.
Press “SNOOZE” (B6) button when alarm alerts. “ ” flashes on the LCD. The
alarm snoozes for around 4 minutes, then it alerts again. The snooze function
can be enabled for maximum 8 times.
When alarm alerts, except “SNOOZE” button, press any other buttons to stop
the alarm. Otherwise, the alarm signal sounds for about 2 minutes, then stops
automatically
5. Thermometer
The temperature measurement range is -9.9°C to +50°C. If the temperature is
out of the measurable range, LL.L (beyond the minimum temperature) or HH.H
(beyond the maximum temperature) will be shown on the LCD.
6. Hygrometer
The humidity measurement range is 20% to 99%. If the current humidity
measurement is lower than 20%, the LCD would display LL%, and it would
display 99% if the current humidity measurement is higher than 99%
7. Precautions
The clock loses its time information when the battery is removed.
Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
Never clean the device using abrasive or corrosive materials or products.
Abrasive cleaning agents may scratch plastic parts and corrode electronic
circuits
To Previous Page
Loading...