Connecting the VK-60 to Your System
For Balanced Preamplifiers:
Use balanced XLR interconnects. The left and right channel input connectors are clearly
marked on the back panel of the VK-60.
Note: The VK-60 XLR inputs are wired as follows:
Pin 1: common/shield
Pin 2: positive
Pin 3: negative
For Single-Ended Preamplifiers:
Single-ended preamplifiers have RCA connectors. The VK-60 power amplifier is
designed to work with either balanced or single-ended preamplifiers connected to its inputs.
All that is required to connect a single-ended preamplifier with RCA connectors to the
VK-60’s inputs is the optional balanced to single-ended adapters. These adapters are
available from Balanced Audio Technology at a nominal charge.
For Speaker Connections:
The speaker connectors are clearly marked on the back panel of the VK-60. There are
several sets of output taps marked LOW, MEDIUM and HIGH for connecting a variety of
speakers to the VK-60. Please note that some experimentation may be required. Try
each output tap until you find the one that gives the most balanced performance in your
system.
To Next Page
Loading...
