Product information Balder Liberty, Finesse and Finesse stand
Label
Contact information
Contact your local dealer if you need help or guidance.
The chair’s standard measurements and weight
The illustration shows the chair’s standard measurements, including neck support. Weight
130 kg
110 cm
113 cm
65 cm
Disconnection/Operation
The drive motors may be disconnected so that the chair can be pushed without using the
electronics. Use the levers marked Operation – Disconnected.
Put the levers into the Operation position to prevent the chair from moving during transporta-
tion. This must be done on a level surface and the chair must be turned off.
Baeries
We conrm that Balder electric wheelchairs are supplied from the factory with batteries.
These are approved in accordance with International Air Transport Association (IATA): Packing
Instruction 872, Special Provision A67.
The batteries are marked with IATA labels.
To Next Page
Loading...
