Balluff BOD 37M-LA01-S92 - Sensor Construction and Connection; Physical Dimensions and Output Function; Installation and Wiring Configuration

www.balluff.com
Construction and function
Installation and connection (continued)
2
english
Dimensions
37
10.1
M12x1
61.7 0.5
11.420.2
3.1°
50.82.5
2.9
47.4
60
Ø
5
4,5
Output function
BOD-37M-…LA…:
MIN
0.2
0
10
V
MAX
mm
Distance
Analog output
BOD-37M-…LB…:
MIN
0
20.0
4.0
3.5
20.5
mA
MAX
mm
Analog output
Distance
Installation and connection
The sensor can be fastened
through two holes in the body (1)
with screws, tightening nuts, and
washers. Only fasten the sensor
to the reference surface marked
with A!
A
1
In case of direct fastening, observe an adjustment angle of
±1.5°. The measurement refers to the front surface of the
laser optics (see figure).
Ref.
1. In a de-energized state, connect the M12 connector to
the sensor.
2. Connect the cable to the supply voltage and I/O as
intended for the respective model.
3. Aim the sensor's laser point at the target and fasten
the sensor in a suitable holder with two screws
(e.g. M4×45, with tightening nuts and washers).
Plug diagram
(Top view of the plug on the BOD)
Pin BOS 37M-LA… BOS 37M-LB…
1 +24V ±20%
2 Q2 (≤100mA)
3 0V
4 Q1 (≤100mA)
5 Q
A
= 0…10V Q
A
= 4…20 mA
Porting configuration
B
+U
0V
2
5
3
1
4
Q2
Q
Q1
A
The measurement function is available just a few
seconds after the device is switched on. To
achieve full accuracy, a warm-up phase of
approximately 20 minutes must be observed.
BOD 37M-LA/LB01-S92
Photoelectric Sensors – Laser Distance Sensor