Balluff Easy Tool-ID BSG TID-05-T30-00-005 - Balluff Standard Data Mapping; Figure 6: Balluff Standard Data Mapping

BSG TID-05-T30-01-005
10
4 The Easy Tool-ID System
4.6. Balluff Standard Data Mapping
To transfer the correct data, you need to have the Balluff standard data mapping on the pre-
setter. This mapping determines the location at which the RFID data carrier stores the infor-
mation and in which format it is stored. Based on that, the Easy Tool-ID system can read the
correct information out of the data carrier and transmit it to the machine tool.
Note
Without Balluff standard data mapping, transmission of the correct data is not
possible. The data mapping can be installed on the presetter by the manufacturer of
the presetter (for example, Zoller).
Figure 6: Balluff Standard Data Mapping