BSG TID-05-T30-01-005
14
The Configuration Software
5.1. System Requirements
• Microsoft Windows 7 (32- or 64-bit)
• .NET Framework 4
• Min. 128 MB available memory
• Min. 100 MB available hard drive space
• 1x USB 2.0 port
• USB data cable
• Balluff Easy Tool-ID hardware
Driver Installation of the Easy Tool-ID Hardware
Caution
Do not connect the hardware to the system until the driver has been successfully
installed using the Easy Tool-ID setup.
If driver installation failed, you can always reinstall it in the program directory of Easy Tool-ID
(usually C:\Program Files (x86)\Balluff GmbH\Balluff Easy Tool-ID\Driver).
Note
The drivers and configuration software only have to be installed on the computer to
be used for configuring the system. This is not absolutely necessary on the HMI.
USB Connection
When the program is started, the Easy-Tool ID software automatically connects to the con-
nected control unit.
Note
Only one control unit may be connected to the system.
If an Easy Tool-ID device is plugged and unplugged while the program is running, the cur-
rent connection status will be displayed directly in the program.
To do this use the Upload tab. See 5.27 Data Transmission.
To Next Page
Loading...