Balluff Easy Tool-ID BSG TID-05-T30-00-005 - Entry Instructions; Figure 12: Incorrect Entries While Creating a Configuration Plan

BSG TID-05-T30-01-005
19
5 The Configuration Software
5.6. Entry Instructions
When creating a configuration plan, you need to note several things:
• The name of a configuration plan must never be blank (no characters).
• The Tool Type must never be blank and must always consist of a number from 0 to
30000.
The Tool Type number is freely selectable and must match with the value on the RFID
chip.
The value is generally written to the RFID chip by the presetter. This means the values
which are used there must also be entered in the Tool Type field.
We recommend using the Siemens tool types from the Siemens 840D Beginner's Man-
ual (11/2006, 6FC5398-1BP10-2AA0)
• The tool type number and name has to be unique.
• A maximum of 30 plans can be created. Once 30 plans have been created the Create
button is grayed out.
If you are making an entry and don't see the green symbol but a red symbol , you can
view the exact error message by moving the mouse pointer over the corresponding symbol.
Figure 12: Incorrect entries while creating a configuration plan