BSG TID-05-T30-01-005
26
5 The Configuration Software
5.13. Special Function "Convert to Diameter"
A presetter always outputs the cross dimension as a radius. However, sometimes the ma-
chine tool needs this value as a diameter. To enable this through the Easy Tool-ID system,
you can use the additional "Convert to diameter" function in the configuration software.
• Select the "Cross Dimension (X)" data field. (1, 2, 3)
• Select the "Convert to diameter" function by checking the box. (4)
• Confirm your entry by clicking "Add". (5)
Figure 19: Selecting the "Convert to diameter" function
To Next Page
Loading...