Balluff Easy Tool-ID BSG TID-05-T30-00-005 - Connection Status; Figure 32: Connection Status of the Easy Tool-ID Hardware

BSG TID-05-T30-01-005
39
5 The Configuration Software
5.26. Connection Status
The connection status of the Easy Tool-ID Hardware is displayed in the application.
Whenever the hardware at an USB port is changed, the connection status and the version of
the connected firmware are automatically updated in the application.
Viewing the connection status
• Click on the Upload tab. (1)
• The current connection status is displayed (in the example no Easy-Tool-ID hardware is
connected). (2)
• A device was plugged into the USB port. (3)
Figure 33: Connection status of the Easy Tool-ID hardware
Note
If a red X (X) is next to the firmware version, then the correct firmware has not been
installed on your Easy Tool-ID hardware.
Please follow the steps regarding this in Chapter 6.