BSG TID-05-T30-01-005
41
Updating the Firmware
6.1. Updating the Firmware
If a red X (X) is displayed next to "FW" in the software, the firmware has to be updated.
This is done by going to Start All Programs Balluff GmbH Balluff Easy Tool-ID and
selecting the "Firmware Update" software. Run this software and follow the displayed steps.
• Start the software.
• If Easy Tool-ID hardware is connected, remove it and then reconnect it. (Repeat this
process if the update does not start on its own.)
• The software updates the firmware. Please do not remove the device.
• The software displays the new firmware version. Now you can continue with the next de-
vice.
-
Figure 35: Updating the firmware
To Next Page
Loading...