WIRING INSTRUCTIONS
FOR BAMONIV TPS OR NIVAPRESS SGE 25 TO CONNECTION HEAD BJSC
Safety Precatutions:
§ Installation, initial start-up and maintenance may only be performed by trained personnel! All applicable
European and national regulations regarding installation of electrical equipment must be adhered to.
§ The device may only be connected to supply power which complies with the specifications included in the
technical data and on the serial plate!
§ The device must be disconnected from all sources of power during installation and maintenance work!
§ The devices may only be operated under the conditions specified in their operating instructions!
Installation / Mounting:
1. Open connection head, remove cable tie and circuit board.
2. Feed the sensor cable from below into the connection head through the cable gland
BAMONIV TPS NIVAPRESS SGE 25
3. Attach cable tie to the sensor cable for strain relief
BAMO Mesures SAS ▪ 22, Rue de la Voie des Bans ▪ 95100 ARGENTEUIL
Tel. +33 (0)1 30 25 83 32 ▪ Fax: +33 (0)1 34 10 16 05 ▪ www.bamo.eu ▪ info@bamo.eu
590 msa590-04 SU3733-1.doc 07/18 1
To Next Page
Need help?
General