B&R ACOPOSinverter X64 User Manual

ACOPOSinverter X64
ACOPOSinverter P64new
Migration manual
Version: 1.20 (December 2019)
Order no.: MAACPIX64-ENG
Translation of the original documentation
All values in this manual are current as of its creation. We reserve the right to change the contents of this manual
without notice. B&R Industrial Automation GmbH is not liable for technical or editorial errors and defects in this
manual. In addition, B&R Industrial Automation GmbH assumes no liability for damages that are directly or indirectly
attributable to the delivery, performance or use of this material. We point out that the software and hardware
designations and brand names of the respective companies used in this document are subject to general trademark,
brand or patent protection.

B&R ACOPOSinverter X64 Specifications

General

Brand	B&R
Model	ACOPOSinverter X64
Category	Inverter
Language	English

Summary

Safety Information

Personnel Qualifications

Details required skills, knowledge, and training for personnel working with the product.

Intended Use

Specifies the product's purpose as an inverter for industrial applications and installation requirements.

Product-Related Information

Details specific hazards related to product use, including electric shock, arc flash, and explosion risks.

Installation

Dimensions and Drill Hole Patterns

Details mechanical data deviations and drill hole patterns for ACOPOSinverter P66/P64new vs X64.

Input and Output Circuit Diagram

Provides diagrams and lists of inputs/outputs for ACOPOSinverter P64new, comparing with X64.

Interfaces

X2X Link

Describes the X2X Link bus receiver, its order data, technical specifications, and pinout.

Implementation

Distinction

Control Behavior

Discusses parameter conversion and control behavior differences between the two inverter models.

Application-Based Differences

Controlling the Holding Brake (Function bLC-)

Defining Permissible Directions of Rotation (Parameter ROT)

Resetting the Parameter Set (Control Word "CMI")

Ramp Switchover (Control Word "CMI")

Operator Change (Control Word "CMI")

Operator Change (Function FLOC)

Extended Control Word "CMI"

Extended Status Word "ETI"

Problems and Solutions

Boot Loop

Addresses issues with the P64new getting stuck in a boot loop and provides a recommended procedure for resolution.