Bang & Olufsen Beolit 600 User Manual

Switch the set on by pulling the knob; rotate clockwise to increase bass.

Turn the knob clockwise approximately a quarter turn from the stop.

Use for tuning stations; adjust volume if necessary for correct reproduction.

Rotate clockwise from the stop to increase the treble range.

Details on Aerial Switch, Telescoping Whip, External Aerial Jack, and Tape Recorder Jack.

Depress buttons to select the desired broadcast band (e.g., FM).

Indicates battery voltage and facilitates tuning by moving the pointer to the right.

Utilizes a high-sensitivity ferrite aerial for LW, MW, and Marine bands.

Employs a telescopic antenna, best extended horizontally for clear signals.

Powered by six D-cell batteries; replace when set does not operate or distorts.

Allows connection of an external speaker, automatically switching off the built-in speaker.

High impedance output for recording off-air or use in hi-fi systems.

Lists frequency ranges for LW, MW, MA, and FM bands in Kc/s and meters.

Details battery type, speaker, dimensions, weight, and output power.

Specifies connections for External Speaker (3.5 ohms) and Tape Recorder (High impedance).

Specifies current draw at low volume, room volume, and 50 mW output.

Describes AM ferrite aerials and FM telescoping aerial, including external connections.

Lists transistors and diodes used in RF, IF, mixer, detector, and amplifier stages.