Need help?Do you have a question about the Banjo 300PH-6 and is the answer not in the manual?
Read instructions for pump drive unit operation, ensure tight connections, and proper placement.
Covers engine operation safety, flammable liquid hazards, and storage preparation.
Details suction and discharge port sizes for 1½", 2", and 3" pumps.
Remove body screws, lock washers, nuts, check valve, volute, and impeller bolt.
Remove impeller using a screw and handle ceramic seal; detach rear bracket.
Remove carbon seal half and polish drive unit shaft if corrosion is present.
Install pump slinger, place seal O-ring, and prepare carbon seal and bracket screws.
Install rear bracket, impeller nut, key, and secure impeller to drive unit shaft.
Install O-ring segment, volute, and check valve onto the rear bracket and volute snout.
Install pump body O-ring and then secure the pump body to the rear bracket.
General| Brand | Banjo |
|---|---|
| Model | 300PH-6 |
| Category | Water Pump |
| Language | English |
To Next Page