Banner DXMR110-8K - Connecting to Remote IO-Link Devices

15 © Banner Engineering Corp. www.bannerengineering.com
CONTROLLER CONNECTIONS FOR THE DXMR110-8K
4.4. Connecting to Remote IO-Link Devices
Use the DXMR110-8K's IO-link ports for connecting IO-Link devices and digital sensors, lights, and actuators. All ports use a 4-pin M12 female
connector to connect to remote devices. No additional wiring is required if the sensors use compatible wiring.
The basic communications parameters for the IO-Link ports are set in the DXM Configuration Software and are saved in the XML configuration
file. Each port can have unique settings.
Figure 2: RTU Configuration screen for ports 1-4
Table 3: Reset codes
Reset Code Definition
0 Undefined
1 Unknown
2 General
3 Brownout
4 Watchdog
5 User
6 Software
7 Return from backup mode
Table 4: Ports 1-4 female connector
Port 1–4 5-pin M12 Connector (female) Pin Wire Color Description
1 Brown (bn) 18 V DC to 30 V DC
2 White (wh) I/Q (digital in-out)
3 Blue (bu) DC common (GND)
4 Black (bk) C/Q (communications/digital in-out)
5 Gray (gy) Not used/reserved
2
3
4
1
5