Banner DXMR110-8K - Quick Start Guide; Apply Power to the Controller; Wiring for the DXMR110-8 K

© Banner Engineering Corp. www.bannerengineering.com 6
QUICK START GUIDE
3. Quick Start Guide
3.1. Apply Power to the Controller
Follow these instructions to apply 12–30 V DC power to the DXMR110-8K using a wall plug.
P
REREQUISITE:
Required equipment:
• DXMR110-8K IO-Link Master
• PSW-24-1 Wall plug power supply; 24 V DC, 1 A (or equivalent 24 V DC M12 power supply)
1. Connect the PSW-24-1 power supply to the male M12 connector on the DXMR110-8K, Port 0.
2. Plug in the PSW-24-1 wall plug power supply.
3.1.1. Wiring for the DXMR110-8K
Figure 1: DXMR110-8K IO-Link Master ports
Table 1: Ports 1-8 female connector
Port 1–8 5-pin M12 Connector (female) Pin Wire Color Description
1 Brown (bn) 18 V DC to 30 V DC
2 White (wh) I/Q (digital in-out)
3 Blue (bu) DC common (GND)
4 Black (bk) C/Q (communications/digital in-out)
5 Gray (gy) Not used/reserved
Table 2: 4-pin M12 male connector
4-pin M12 Power Connector (male) Pin Wire Color Description
1 Brown (bn) 18 V DC to 30 V DC
2 White (wh) 18 V DC to 30 V DC
3 Blue (bu) DC common (GND)
4 Black (bk) DC common (GND)
4132
8576
DXMR110-8K
1
2
P
o
P
i
Device LEDs (x16)
M12 Power Port
(Male)
D-Coded Ethernet
(Female)
D-Coded Ethernet
(Female)
IO-Link Master Ports 1-4
(Female)
IO-Link Master Ports 5-8
(Female)
M12 Power Port
(Female)
2
3
4
1
5
1
4
3
2