EZ-SCREEN LS Safety Light Screen
p/n 190579 Rev A 4
Sensor configured for Scan code 1
Sensor configured for Scan Code 2
Note: both emitter and receiver must be configured for the same Scan Code
Emitter LED Problem - This is not an error that would immediately result in a lockout. This
indication can occur due to a potential problem with an LED and is provided as an early warning
indicator.
Error Code (with flashing RED status indicator)
This error can occur if the ID Input (pin 3, Orange) is not connected to +24 V dc.
Excessive electrical noise or an internal failure can also cause this error.
Possible corrective action(s):
• Verify that the ID Input (ID_in) wiring is connected to +24 V dc. See Generic
Wiring Diagram—5-pin and 8-pin Emitter in the instruction manual
• Cycle the power to the emitter per Recovery Procedures in the instruction
manual
• If the error clears, perform the daily checkout procedure (per EZ-SCREEN
Checkout Procedures: Shift and Daily Checkout Procedure; Daily Checkout
Card). If the System checks out, resume operation. If the System fails,
replace the emitter
• If the error continues, check the ground connection (see Cordsets in the
instruction manual)
• If the sensor has a good earth ground connection, check for electrical noise
(see Electrical and Optical Noise in the instruction manual)
• If the error persists, replace the emitter
To Previous Page
Loading...