Installation:
Please ensure that the equipment you are
connecting to the Bantam Gold meets the
specifications described in the diagram
above.
Place the Bantam Gold on a flat sturdy
surface and connect your equipment as
shown in the above diagram.
Do not connect the speaker output terminals
to each other, or to ground. This will cause
the Amplifier to go in to self protection mode.
Turn the volume knob to minimum by
rotating the volume knob anticlockwise,
then press the power on button to turn the
Bantam Gold ON.
Play music through your sound source and
slowly increase the volume by rotating the
volume knob on the Bantam Gold clockwise
until the volume is at your desired listening
level.
If you have turned the volume knob to
maximum and you still require a higher
volume, increase the gain level by following
the instructions (high and low gain) on the
following page.
LeftRight
RL
Speakers: >3.5 ohms. > 85dB
Sound source: Line level signal.
Power Supply: 9 - 18V DC >2A
2.1mm Plug center pin positive
2
To Next Page
Loading...