Barco AMM240ED - Advanced

17R5912858 /05 AMM240ED
The picture may be disturbed when the frame frequency of the main screen is different from that of
the subscreen, or when the main screen and the subscreen input interlace signals.
PIP Menu
The available settings are:
• Mode: PIP Mode On / Off
• Source: PIP Sub Screen Source - DVI-I, HD/SD SDI1, HD/SD SDI2
8
Component/RGBs, HD15, Y/C
• Position: PIP Sub Screen Position - Top L, Top R, Bottom L, Bottom R
• Size: PIP Sub Screen Size - Small, Medium, Large
• Blending: PIP Sub Screen Blending (Range 0 - 20)
• Swap: PIP Sub Screen Swap
POP Menu
The available settings are:
• Mode: POP Mode On / Off
• Source: POP Sub Screen Source - DVI-I, HD/SD SDI1, HD/SD SDI2
9
Component/RGBs, HD15, Y/C
• Position: POP Sub Screen Position - Top L, Top R, Bottom L, Bottom R
• Size: POP Sub Screen Size - Small, Medium, Large
• Blending: POP Sub Screen Blending (Range 0 - 20)
• Swap: POP Sub Screen Swap
PBP Menu
The available settings are:
• Mode: PBP Mode On / Off
• Source: PBP Sub Screen Source - DVI-I, HD/SD SDI1, HD/SD SDI2
10
Component/RGBs, HD15, Y/C
• Swap: PBP Sub Screen Swap
4.4 Advanced
About advanced
The available functions are:
• OSD Position Control: Change the OSD Menu - H and V Position, Background, OSD Time Out,
Language
• Screen Control: Control and Adjust H and V position, Freqency, Phase, Noise Reduction, Motion Offset
• DPMS: Change the DPMS - Off, 60 min, 90 min, 120 min, Normal
• Auto Source Select: Adjust Auto Source Select Between On and Off
• Smart Select: Enable / Disable Smart Select Sub Menu - Model A, Model B Model C, Model D
• Restore Factory: Changes All OSD Value to Factory Outgoing Status
• Key Lock: Set to Key Lock Mode
• Overscan: Adjust Overscan Ratio - Off, Step 1, Step 2, Step 3, Step 4, Step 5, Step 6, Step 7
OSD Position Control Menu
The available settings are:
• H Position: Adjust OSD H Position (Range 0 - 100)
• V Position: Adjust OSD V Position (Range 0 - 100)
• Background: Adjust Transparency of OSD Background (Range 0 - 20)
• OSD Time Out: Adjust OSD Time Out - 5 sec, 10 sec, 15 sec, 20 sec, 1 min, 2 min
• Language: OSD Language - English, Japanese, Chinese, Korean, French, German
Advanced operation
8. When a HD/SD SDI optional module is connected, HD/SD SDI2 is applicable to the source for PIP mode.
9. When a HD/SD SDI optional module is connected, HD/SD SDI2 is applicable to the source for POP mode.
10. When a HD/SD SDI optional module is connected, HD/SD SDI2 is applicable to the source for PBP mode.