3. Mechanical set up of the DP-1500
3.1 Unpacking the projector
What has to be done ?
At delivery the projector is packed in a carton box upon a wooden pallet and s ecured with banding and fastening clips. Furthermore,
to p rovide protection during transportation, the projector is surrounded with foam. O nce the projector is ar rived at the installation
site, it has to be removed from the carton box and wooden pallet in a safe manner without damaging the projector.
After unpacking let the projector acclimate to the room temperature which must be higher then 10°C (50°F)
and lower then 35°C (95°F). Neglecting this may result in a start up failure of the Light Processor Un
it.
Necessary tools
• 8 mm Allen wrench.
• 13 mm open end w rench.
• 17 mm open end w rench.
How to unpack the projector ?
1. Remov e the banding around the carton box, by releasing the fastening c lips as illustrated, and open the box.
Image 3-1
2. Remov e the smaller carton box (reference 1) a s illustrated.
Note: The smaller carton box contains the manual.
1
2
3
Image 3-2
3. Remov e the c arton box and the foam around the projector. See image 3-2.
Note: The projector is still attached to a wooden plate, which is secured the below pallet.
4. Loosen the four nuts (reference 2 image 3-2) which secure the pallet as illustrated. Use a 13 m m open end wrench.
5. Rotate the wo oden support plate with projector 90° and slide the front s ide over the edge of the pallet until the fixa t ion screw
(reference 4) is v isible as illust rated.
6. Remov e the hexagon socket head cap
screw(reference4). Usean8mmAllenwrench.
22
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
