Barco DP-1500 - Connecting the Main AC Power

4. Electrical set up of the DP-1500
4.2 Connecting the main AC power
Necessary tools
• Flat screw driver.
• Phillips screw driver P H2.
Necessary parts
• Two cable ties.
•Certified AC p ower supply cord 4.0 mm², 10AWG, min. 300V.
How to connect the main AC power with the DP-1500 projector?
1. Remov e the rear c over and lamp cover of the projector.
2. Remov e the cover of the main AC co mpartme nt by releasing the three c aptive dum b screws.
Image 4-1
3. Guide the A C pow er cord through the cable gland and connect the wires to the 3-terminal strip as illustrated.
Warning: Always connect first the PE wire.
PE
Image 4-2
4. Secure the power c ord with the chassis of the projector by using two cable ties (A) and by fastening the cable gland ( B) as
illustrated.
Note: The first production series of the DP-1500 have the power cord entrance at the rear as showed in image 4-4. In this case
no cable ties can be used.
R59770091 DP-1500 06/01/2009
31