6. Lamp & lamp house
6.2 Removal of the lamp house
WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Lamp casing is very hot after operation. To avoid burns, let the projector cool down for at least 15
minutes before proceeding to the lamp unit replacement.
CAUTION: Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
handled.
Necessary tools
7mmflat screw driver.
How to remove the lamp house of the projector ?
1. Switch off the pr ojector.
2. Remov e the lamp cover.
3. Release the three spring lock screws of the lam p house as illustrated.
Image 6-3
4. Hold fast the lamp house by the handles and pull the lamp house o ut of the projector.
Caution: Beware of the weight of the lamp assembly. Take the necessary precautions to avoid personal injury.
Image 6-4
5. Place the lamp hous e on a stable support.
R59770091 DP-1500 06/01/2009
47
To Next Page
Loading...
