6. Lamp & lamp house
6.5 Installation of the lamp house
WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
handled.
Necessary tools
7mmflat screw driver.
How to install the lamp house of the projector ?
1. Ensure the projector is s witched off.
2. Remov e the lamp cover.
3. Hold fast the lamp house by its handles and gently slide the lamp house into its socket. N ote that the compartment is provided
with guides (G) t o position the lamp house correctly.
G
C
Image 6-19
4. Push the lamp house forward until it s lides fully into the projector.
5. Secure the correct position of the lamp house by tightening all three spring lock screws as illustrated.
Image 6-20
6. Reinstall the lam p cover of the projector.
R59770091 DP-1500 06/01/2009
57
To Next Page
Loading...
