8. Communicator touch panel
8.2 Installing the touch panel interface
Necessary tools
• 17 mm wr ench.
• 10 mm wr ench.
How to install the touch panel interface upon the DP-1500 projector?
1. Assemble the mounting p late and the swivel arm together as illustrated. F irst the nut (N) upon the rod of the m ounting plate, then
the lock washer (L), and then fasten moun ting plate and swivel arm together. When arm is mounted, turn nut (N
) against the arm
to secure the position.
N
L
Image 8-3
2. Slide a w asher (M) over the base of the swivel arm and Insert the base of the sw ivel arm into the m ounting hole at the top of the
DP-1500 projector as illustrated.
M
Image 8-4
3. Place the touch panel interface upon the mounting plate of the swivel arm and fasten the two wing nuts (W) a s illustrated.
W
Image 8-5
4. Connect the circular plug of the multi cable with the circular socket at the rear side of the DP-15 00 projector.
74
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
