1. DP4K-L series accessory kit
1.10 Installing th e castor wheels
CAUTION: Only use castor wheels in case the surface where the chiller will stand is
leveled.
CAUTION: Do not stack chillers with castor wheels mounted!
Necessary tools
• Open end wrench 17 mm
•Forklift
How to install the castor wheels on the chiller
1. Raise the chiller without tilting about 25 cm above the floor . Use a forklift.
Caution: Donottiltthechiller!
2. Turn the four feet out of the chiller bottom plate. Use a 17 mm open end wrench to loosen the lock nut
of the foot.
3. Screw in the castor wheels. Use 17 mm open end wrench to fasten the castor wheel.
Image 1-17
R5905882 DP4K-L ACCESSORY KIT 06/09/2017 13
To Previous Page
Loading...
