9. Image
9.5.1 Source timings
Adjustable items
• Horizontal start in pixels : number of pixels between the horizontal sync and active video information in the input signal.
• Horizontal Active = Active horizontal pixels (width) : number of active pixels in the input signal. This value is normally given in
the source specifications. If not, adjust until full image is displayed (no missing pixels).
• Vertical start in lines : number of lines between the vertical sync signal and active video information in the input signal.
• Vertical Active = Active vertical lines : number of active lines in the input signal. This value is normally given in the specification
of the source. If not, adjust until full image height is displayed (no missing lines).
• Total pixels: Total horizontal pixels in the source. If the value is wrong, sampling mistakes (small vertical bars in the projected
image) will be seen in the image.
• Total lines: Total lines in the source.
How to set up
1. Press Menu to activate the menus and select Image → Timings.
Image 9-45
Main menu, Image
Image 9-46
Image, timings
Image 9-47
Timings window
2. Press ENTER to select.
3. Use the ▲ or ▼ key to select a setting.
4. Use the ◄ or ► key to change the value
Or,
press ENTER to open the specific adjustment menu. Follow the adjustment method as described in "Navigation and adjust-
ments", page 89.
5. Continue with the other settings in the sa
me way until all timings are set.
134
R5905032 HDX SERIES 01/06/2011
To Next Page
Loading...
