5. Advanced operation
5.7 Ethernet ove r USB
About Eth. over USB
By default, the Ethernet over USB will be disabled. This does not disable the USB hub and still allows
to make use of the display’s USB downstream connectors and any external devices connected to it (key-
board,mouse,...).
Please note that a connection from a PC USB downstream connector to the display’s USB upstream
connector is required to be able to use this functionality.
By enabling the Ethernet over USB, you allow the internal Mammo Tomosynthesis processor to commu-
nicate directly over USB with the connected PC.
Enabling the Ethernet over USB is only recommended when you are using a non-Barco
display controller. If you are using a Barco display controller, this communication will
automatically be done ove r the connected video ca ble(s).
To enable/disable the eth. over USB:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Connectivity menu.
3. Enter the Eth. over USB submenu.
4. Select Enabled/Disabled as desired and confirm.
5.8 USB
About USB
By default, USB will be enabled. This will allow the connected PC to communicate directly over USB with
the internal Mammo Tomosynthesis processor.
By disabling USB, communication between the internal Mammo Tomosynthesis processor and the con-
nected PC will not be possible. This does not disable the USB hub and still allows to make use of the
display’s USB downstream connectors and any external devices connected to it (keyboard, mouse, ...).
Please note that a connection from a PC USB downstream connector to the display’s USB upstream
connector is required to be able to use this functionality.
Enabling the USB endpoint is only recommended when you are using a non-Barco dis-
play controller. If you are using a Barco display controller, this communic ation will au-
tomatically be done over the connected video cable(s).
To enable/disable USB:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Connectivity menu.
3. Enter the USB submenu.
4. Select Enabled/Disabled as desired and confirm.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
25
To Next Page
Loading...
