5. Advanced operation
No Conversion
Use Red Channel This mode is intended for grayscale displays where
gray is sent over the red channel.
Use Green Channel This mode is intended for grayscale displays where
gray is sent over the green channel.
Use Blue Channel This mode is intended for grayscale displays where
gray is sent over the blue channel.
Use All Channels This mode is intended for grayscale displays where
gray is sent over the red, green and blue channel.
This is done by means of a standard conversion
mechanism where 30% red, 59% green and 11%
blue are used to generate gray.
To manually select a grayscale conversion mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Source menu.
3. Enter the Grayscale Conversion submenu.
4. Select one of the available color conversion modes and confirm.
5.24 EDID timings
About EDID t imings
Following EDID timings are available for your Mammo Tomosynthesis:
Refresh Rate Allows to manually select the refresh rate of the
image source video input signal depending on the
maximum refresh rate of the display controller
connected to your display.
Preferred Orientation Allows to change the orientation of the image
source video input signal to landscape, portrait or
to let the display automatically assign the correct
orientation.
Color Depth
Allows to change the color depth to 8 or to 10 bit.
To manually set EDID timings:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Source menu.
3. Enter the Timings submenu.
4. Select Refresh Rate, Preferred Orientation or Color Depth.
5. Select one of the available settings and confirm.
5.25 Display info
About display info
Your display serial number, color type, native resolution, firmware versions, etc. are available in a dedi-
cated submenu of the OSD menu.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
35
To Next Page
Loading...
