Operation
30
• Automatic Phase: The image should contain sharp black-white
transitions, like a line pattern or characters.
• Automatic Gain: The image should contain parts that are
completely black (0% video amplitude) and parts that are full
white (100% video amplitude).
Video Contrast
This menu is not available in DVI mode.
Video contrast adjusts the brightest elements in the image on the
screen, while the darkest elements are not adjusted.
Note: Adjusting video contrast may affect the number of
grayscales in the image. Therefore we advise to leave video
contrast in calibrated position.
Video Brightness
This menu is not available in DVI mode.
Video brightness adjusts all levels in the image on the screen, from dark
to bright.
Note: Adjusting video brightness may affect the number of
grayscales in the image. Therefore we advise to leave video
brightness in calibrated position.
Instead, if you feel the image is too bright or too dark, try adjusting the
Luminance (see further).
Name Description
Contrast CAL Pos Switch to calibrated position of contrast
Man Contrast adj Manually adjust contrast
Name Description
Brightness CAL Pos Switch to calibrated position of brightness
Man Brightness adj Manually adjust brightness
To Next Page
Loading...
