Operation
40
Standard input mode
Name Description
RGB->RGB The R video signal drives the R sub-pix-
els, the G video signal drives the G sub-
pixels and the B video signal drives the
B sub-pixels. This is the preferred set-
ting for color display controllers.
RGB->Y The RGB video signals from the imaging
board are calculated and transformed
into a single luminance value according
to the formula 0.3R + 0.59G + 0.11B.
This single luminance signal drives the
RGB sub-pixels of the panel equally.
Use this setting in case the imaging
board is a color board and if the signal
must be displayed in monochrome.
R->Y The Red video signal from the imaging
board is used as luminance value to
drive the RGB subpixels of the panel
equally.
G->Y The Green video signal from the imag-
ing board is used as luminance value to
drive the RGB subpixels of the panel
equally.
B->Y The Blue video signal from the imaging
board is used as luminance value to
drive the RGB subpixels of the panel
equally.
To Next Page
Loading...
