Operation
39
Note: If you execute an Automatic Geometry function after these
adjustments, all manual offsets will be erased.
Name Description
Left offset This function allows you to make an offset to the
start (left) position of the active video. As you
adjust this value, another pixel will be chosen as
starting pixel. The active line width is not changed
by this adjustment. As a visual result, the image
moves horizontally.
Right offset This function allows you to make an offset to the
end (right) position of the active video. As you
adjust this value, another pixel will be chosen as
last pixel per line. This adjustment alters the
active line width.
Remark that the active video is always centered
on the screen while this adjustment is made.
Top offset This function allows you to make an offset to the
start (top) line of the active video. As you adjust
this value, another line will be chosen as first line.
Bottom offset This function allows you to make an offset to the
end (bottom) line of the active video. As you
adjust this value, another line will be chosen as
last line.
To Next Page
Loading...
