Barco NIO 5MP - Software Installation; Software Installation Overview

Software installation
40 System manual Nio 5MP
Software installation
Software installation overview
These instructions apply to both Windows 2000 and
Windows XP.
Preparation
Prior to installing your Nio software the following should
be done.
1. Install the BarcoMed Nio display controller in your
system.
2. Connect the Nio display panel to the BarcoMed Nio
display controller and power supply.
3. Decide if you are going to install the BarcoMed Nio
driver with DualView enabled or disabled.
4. Decide what palette mode you want to use.
5. Decide if you want to enable the DirectDraw
capabilities of the BarcoMed Nio display controller.
6. Decide if you want to install NioWatch.
7. Put the Nio display panel in portrait position before
installing the software. If you wish to change the
panel orientation later, the image orientation will
adapt automatically to the panel orientation after
rebooting the PC.
Caution: Both displays connected to a single display
controller must have the same physical orientation
and resolution in order to be attached to the
Windows desktop. This is a requirement of the
Windows operating system.