Software installation
System manual Nio 5MP 53
10.When the screen shown in figure 30 below appears
select the palette mode you wish to use and if you
want to enable DirectDraw and click “Next”.
Figure 30
When the Driver Install Wizard tells you that it has
successfully installed the selected driver, click
“Finish”.
The wizard will now begin installing the next selected
piece of BarcoMed Software. If you are working with
the default selections, this will be the Barco NioWatch
InstallShield Wizard. Please turn to the section,
“Barco NioWatch Software Installation”.
Note: Clicking “Cancel” will also return you to the
BarcoMed Product Install Wizard, but will not delete
the Barco Display Driver. The wizard will also begin to
install the next selected piece of BarcoMed Software.
If the Wizard failed to successfully install the
selected driver, it will warn you that the installation
failed. Click “Finish” to return to the BarcoMed
Product Install Wizard. The wizard will now begin
To Next Page
Loading...
