Software installation
54 System manual Nio 5MP
installing the next selected piece of BarcoMed
Software. Click “Cancel”, then click “Yes” then click
“Finish”. Now “Back” and try reinstalling the driver
following the steps above or using the steps outlined
in “Reinstalling or Updating your BarcoMed Drivers”
section found later in this chapter.
BarcoMed Nio Watch installation
1. Click “Next” on the Welcome Screen of the BARCO
NioWatch InstallShield Wizard (figure 31) to begin
the installation or click “Cancel” to cancel and return
to the BarcoMed Product Install Wizard.
2. After reading the Software License Agreement on the
next screen, click “Yes” to continue.
3. Click “Next” on the Choose Destination Location
screen to install the NioWatch software in the
default location. Or click “Browse” to install the
software in a different location.
Figure 31
4. Click “Next” on the Select Program Folder screen to
install the NioWatch software in the default location.
To Next Page
Loading...
