7. Advanced
Image 7-115
5. Press ENTER
The projection can also be interrupted using the PAUSE key on the RCU. To restart the image projection press
PAUSE
7.8.3 Freeze
Freezing the image
With the Freeze function, the image can be frozen. To restart the image, reuse the Freeze function or press the FREEZE button on
the remote.
How to freeze the image ?
1. Press MENU to activate the Tool bar
2. Press → to select General
3. Press ↓ to Pull down the General menu
4. Use ↑ or ↓ to select Freeze
Image 7-116
5. Press ENTER to activate the Freeze function
The image can also be frozen using the FREEZE key on the RCU
7.8.4 Standby Timer
What can be done ?
If there is no signal, and the standby timer is enabled, a dialog box is displayed and the projector will shut down after a pre determined
time.
The countdown time can be set in a dialog box in a range from 180 to 3600 seconds (default value = 300). The Timer can also be
disabled.
How to enable the timer ?
1. Press MENU to activate the Tool bar
2. Press → to select General
3. Press ↓ to Pull down the General menu
4. Use ↑ or ↓ to select Standby Timer
116
R59770286 NW-12 07/09/2009
To Next Page
Loading...
