Barco NW-12 - Page 129

7. Advanced
Red L Red Light output
Green L Green Light output
Blue L Blue Light output
White L
White Light Output = Red + Blue + Green Light output
Desired Values These are the colors you want the projector to display when the status is enabled
Red x, y Coördinates for the Red point
Green x, y Coördinates for the Green point
Blue x, y Coördinates for the Blue point
Cyan x, y Coördinates for the Cyan point
Yellow x, y Coördinates for the Yellow point
Magenta x, y Coördinates for the Magenta point
White x, y Coördinates for the White point
Red L Red Light Output
Red Lmax Maximum available Red Light Output
Green L Green Light Output
Green Lmax Maximum available Green Light Output
Blue L Blue Light Output
Blue Lmax Maximum available Blue Light Output
Cyan L Cyan Light Output
Cyan Lmax Maximum available Cyan Light Output
Yellow L Yellow Light Output
Yellow Lmax Maximum available Yellow Light Output
Magenta L Magenta Light Output
Magenta Lmax Maximum available Magenta Light Output
White L White Light Output
White Lmax Maximum available White Light Output
Factory Preset Sets the measured parameters back to the factory preset for the current set
Calibration This starts the calibration procedure for the measured points of the current set (Changing these
settings may seriously affect the performance of the projector).
Default Desired This will reset the desired parameters to no color change values (measured values). This can be
interesting to recalculate the second
ary colors.
R59770286 NW-12 07/09/2009 125