7. Advanced
The soft edge dialog box will be displayed.
8. Uncheck all the edges
9. Adjust the soft edge as desired (same procedure as above)
10.Press BACK to return to the D isplay setup menu.
7.9.8 AutoImage Setup
What can be done ?
AutoImage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the display.
AutoImage can adapt the image based on following data :
• Total pixels/ lines
• Start pixel/lines
•Phase
• Contrast/brightness levels
AutoImage works only for data signals.
To launch Autoimage, see AutoImage in the Image files menu
How to set up AutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select A utoImage setup
Image 7-173
5. Press ENTER
A dialog box is displayed.
Image 7-174
R59770286 NW-12 07/09/2009 151
To Next Page
Loading...
