Barco RLM W8 - Page 52

- 52 -
Operation Commands Values
Execute
(none)
Performs an action such as a reset.
Motor operation command:
For motor control like lens shift, focus and zoom, the parameters “+” and “-” are defined as
follows.
Command item command System Action
focus + -
+ => Focus Near,
- => Focus Far
zoomio + -
+ => Zoom out
- => Zoom in
vert.offset + -
+ => Up
- => Down
horiz.offset + -
+ => Right
- => Left
Lens.center (execute) Midposition shift
Get operations command example:
Input: op bright ? [CR]
System Response: OP BRIGHT = 100
Increase & Decrease operations command examples:
Input: op bright + [CR]
System Response: OP BRIGHT = 101
Input: op bright - [CR]
Response: OP BRIGHT = 126
Set operations command example:
Input: op bright = 127 [CR]
System Response: OP BRIGHT = 127
Execute command example: