Barco UDM 4K15 - 12.1 About the projector scheduler; 12.2 Adding a new command in the scheduler

R5911443 /11 UDM184
12.1 About the projector scheduler
About the scheduler
From Pulse software 2.3 onward, the projector scheduler is now available to use. The projector scheduler
allows you to automate the weekly schedule of the projector. This includes:
• Powering up the projector
• Selecting and activating a predefined projector profile.
• Powering down the projector
How to open the scheduler
1. In the main menu, select Scheduler.
Image 12–1 Main menu, Scheduler menu icon
2. The current scheduler will be displayed.
Image 12–2 Example of a cleared Scheduler menu
Make sure the Enabled slider is set to the right and lit blue. If not, the Scheduler will not be active.
12.2 Adding a new command in the scheduler
How to add a new command
1. In the Scheduler menu, select Add Command.
The Add Command page is displayed.
GUI – Projector scheduler