Barco UDM Series - Choosing the Desired Display Setup

R5911443 /02 UDM104
Source
Layout mode
Video Timing /
cable
Fixed
configuration?
Color depth
Active Stereo
(sequential L/R)
Standard layout (1x1
layout)
2560 x 1600 @120
Hz
30 bpp
Active Stereo
(sequential L/R)
4 Column mode (4x1
layout)
960 x 2160 @120 Hz 30 bpp
Active Stereo
(sequential L/R)
4 Quadrant mode
(2x2 layout)
1920 x 1080 @120
Hz
30 bpp
Passive Stereo
(separate L/R)
Standard layout (1x1
layout)
3840 x 2160 @60 Hz
• Cable 1: left eye
• Cable 2: right eye
30 bpp
Passive Stereo (dual
pipe L/R)
2 Column mode (2x1
layout)
1920 x 2160 @60 Hz
• Cable 1: left eye,
left column
• Cable 2: left eye,
right column
• Cable 3: right
eye, left column
• Cable 4: right
eye, right column
30 bpp
8.11.4 Choosing the desired Display Setup
Output modes
The following output modes are available:
• AutoStereo: Automatic mode (2D input = 2D output, 3D input = Active Stereo output).
• Mono: Forces all source signals to 2D output.
• ActiveStereo: Forces all source signals to Active Stereoscopic 3D.
Use the following table as an indicator of what display mode you require.
Source signal
AutoStereo Mono ActiveStereo
2D Source Output is a 2D image Output is a 2D image Output is in Active Stereo
Active Stereo source Output is in Active Stereo Output is a 2D image Output is in Active Stereo
Passive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active Stereo
When a different Display Mode is chosen compared to the source signal (e.g. Active Stereo source
with Mono output), advanced image processing will make sure you a desirable image will be
displayed.
How to select the desired projection method?
1. In the main menu, select Installation → Display Setup.
Image 8-70: Installation menu, Display setup
The Display setup menu is displayed.
Image 8-71: Display setup menu
GUI – Installation