Barco UDM Series - Enable Profiles

R5911443 /02 UDM 109
Area of interest
Settings
Installation
• Lens parameters, if available (only valid if recalled with same lens)
- Iris
- Focus
- Zoom
• Lens shift (Vertical / Horizontal)
• Motorized Frame parameters, if connected
- Rotate
- Tilt
- Skew
• Shutter position
• Image orientation
• Scaling mode
Warp settings Note: Only file-based warp supported via profiles
• Warp enabled status
• Selected warp file
• Transport delay
Blend
• Mask blend
- Enabled status
- Start and Width for each side
• File blend
- Enabled status
- Selected files
• S-curve ("gamma")
Black Level
• Mask Black level
- Enabled status
- Width for each side
• File Black level
- Enabled status
- Selected file
• R/G/B gain values
Illumination
• Illumination power for each source
• CLO enabled status
• CLO setpoint
Display
• Display mode (ActiveStereo, AutoStereo or Mono)
• 3D settings
- Dark time value
- Swap Frame Pair On/Off
- Sync Delay value
- Sync Delay Invert On/Off
9.3 Enable Profiles
1. Adjust the necessary projector set up values for the actual user case as described in the specific topics in this
manual.
2. Enter the menu Home/Profiles/New
When pressing OK (confirm selection (✓)), a keyboard will show up.
GUI – Profiles