R5911443 /02 UDM 123
Image 10-19: DMX menu
2. Choose the desired DMX mode.
3. Choose the desired starting channel.
4. Choose whether or not you want the Auto power-down feature to be enabled. If enabled, determine the time-
out.
5. If required, enable Art-Net. If enabled, determine the desired Art-Net Universe and Art-Net channel.
6. If a front XLR connector is available on your projector, you can enable the output voltage on this connector.
10.5 Front XLR output voltage control
What can be done?
The output voltage on the front XLR connector can be enabled or disabled. If enabled, the output voltage level
can be set to 0 V, 12 V or 24V.
The output voltage depends on the application or peripheral used. For example, the optional external
mechanical shutter requires 12 V. The motorized rigging frame on the other end requires 24 V.
DMX Art-Net can also enable the output voltage on the front XLR connector. To avoid that per accident a
voltage is activated via DMX Art-Net, set the power level to 0 V.
How to enable or disable?
1. In the main menu, select System Settings → Communication → DMX.
Image 10-20: Communication menu, DMX
The DMX menu is displayed.
GUI – System Settings
To Next Page
Loading...
