Barco UDM Series - Power On the Projector

R5911443 /02 UDM26
The RCU will not function properly if strong light strikes the IR sensor window or if there are obstacles
between the RCU and the IR sensor.
45°
45°
45°
45°
45°
45°
Image 2-5
For detailed info about the RCU see chapter “Pulse Remote Control Unit”, page 31.
2.2 Power on the projector
How to power on
1. Does the OVERVOLTAGE status light (reference 1) lit up?
► If yes, pull out the power cord immediately. Contact a qualified technician to check the power net.
Warning: Never switch on the projector if the OVERVOLTAGE status light lit up. Neglecting will cause
irreversible damage to the projector.
► If no, proceed with the next step.
2. Press the mains switch (reference 2) to switch on this projector.
2
1
OVERVOLTAGE
Image 2-6
• When '0' is pressed, the projector is switched off.
• When 'I' is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved.
Once in standby mode, the Power on/off button will be lit WHITE, but the display will be off.
Image 2-7
3. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is ready.
Once the projector is ready, the Power button will be lit BLUE.
Getting Started