R5911443 /02 UDM 27
The start up screen is displayed on the touch panel and when fully started up, it changes to the overview
screen.
Image 2-8
The background image of the startup screen and info screens can be changed with Projector
Toolset with an installed UDM plug-in.
2.3 Start image projection
Connect the source
1. Connect the source cable with the appropriate input port on the Input & Communication module.
Tip: See chapter “Input & Communication”, page 39, for more info about supported input formats.
Image 2-9: Example of connecting an HDMI source.
2. Check if the SYNC LED lit up ORANGE (reference 1). This indicates that the sync is detected on the input
signal.
Image 2-10
Select the source
1. Press the Input button (reference I ) on the remote control or local keypad.
Getting Started
To Next Page
Loading...
