Barco UDM Series - Displaying a Single Source; Displaying Multiple Sources Stitched Layouts

R5911443 /02 UDM56
6.1 Displaying a single source
About selecting a source
Before a source can be projected, the source signal must be connected to the source input(s) of the device
and a valid synchronization signal must be available along with the source signal on at least one of the input
connectors.
How to select?
1. Press Menu to activate the menus and select Source.
Image 6-1: Select Source
2. Press OK.
The Select Source menu is displayed with the actual available sources filled out.
3. Select the desired input.
6.2 Displaying multiple sources: Stitched layouts
About stitched layouts
The first time you use a selected single source, the source will be displayed in the projector's native resolution.
If the resolution of the source is different to the projector's resolution, the image is stretched or shrunk.
It is however possible to configure and display two or four source signals to make up one single image in full
native resolution. This is called a Stitched Layout: the sources are stitched together.
The following table lists which stitched layouts you can use, and in which display mode these layouts can be
used.
The table below describes the different Stitch Layouts and scan directions.
Type of layout Description
Available connectors Mode
1
: Single
A single source is displayed in
full screen
Quad Combo input:
• SDI (4x)
• HDBaseT (2x)
• DisplayPort
• HDMI
Quad DP 1.2 Input:
• DisplayPort (4x)
Mono / Active
stereo
1 2
: Dual 1 x 2
Two inputs are required. The
sources are displayed next to
each other.
Quad DP 1.2 Input:
• 2x DisplayPort
Mono / Active
stereo
1 2
3 4
: Quad 2 x 2
Four inputs are required. The
sources are displayed in four
quadrants.
Quad Combo input:
• 4x SDI input
Quad DP 1.2 Input:
• 4x DisplayPort
Mono / Active
stereo
GUI – Source