R5911443 /02 UDM 85
Image 8-25
4. To set warping on one of the four corners, select one of the four corners and confirm.
5. Set the desired X and Y coordinates for this corner, using the arrow keys, and confirm.
Image 8-26
Tip: A red border corner will be projected along with the current image. The border is a visual aid,
showing the result of the warped corners.
6. Repeat from go to step 4 for each corner, until all corners are warped in the desired position.
To reset the 4 corner adjustments, select Reset and press the OK button.
8.7.4 Warping – Bow
About bow adjustment
A bow distortion can be adjusted so that a normal image is displayed. Positive adjustments introduce more
outside bow distortion. Negative adjustments introduce more inside bow distortion.
GUI – Installation
To Next Page
Loading...
