R5911443 /11 UDM170
Image 10–72 Example of the electronic convergence menu
2. Select the desired X or Y value for one of the three colors and confirm.
3. Use the arrow keys to raise or lower the value and confirm.
4. Confirm all changes by pressing Enter.
Image 10–73
Tip: Press Reset to return all values to the factory settings.
5. Repeat all steps until the desired alignment is achieved.
10.21 Operational mode
Overview
The UDM range now offers you a possibility to choose the most relevant user mode for your application. You
can select, setup and tweak the mode which you need, while a smart monitoring algorithm in the background
keeps on balancing and optimizing between illumination output power, minimal noise level and optimized
temperature household.
These are the presets being offered to start from:
1. “Normal mode”: This is the standard mode delivering highest possible brightness while ensuring a life time
of 20 000 hours and keeping the noise level around 48 dBA.
2. “Silent mode”: controlling maximal fan speed staying 47 dBA.
How to change the operational mode of your projector
1. In the main menu, navigate to Settings → System → Operational mode.
GUI – System Settings
To Next Page
Loading...
